[. . . ] Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: • Install all batteries correctly, + and - as marked on the unit. • Batteries (packed or installed) shall not be exposed to excessive heat such as sunshine, fire or the like. liquid filled objects, lighted candles). 2 EN • Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• Never remove the casing of this device. [. . . ] If you contact Philips, you will be asked for the model and serial number of this apparatus. ___________________________ FM SPEAKER OUT (8 ) ANTENNA Connect speakers Note •• For optimal sound, use the supplied speakers only. •• Connect only speakers with impedance that is the 100-240 V~50/60 Hz AC MAINS~ same or higher than the supplied speakers. Refer to the Specifications section of this manual. Demonstrate the features In the standby mode, you can demonstrate features by pressing . »» The features are displayed one by one across the display panel. SPEAKER OUT (8 ) FM SPEAKER OUT (8 ) ANTENNA 100-240 V~50/60 Hz AC MAINS~ • To turn off the demonstration, press again. Prepare the remote control Caution •• Risk of explosion!When the remote control is not used for long periods, remove the batteries. Never discard batteries in fire. EN 7 To insert the remote control battery: 1 2 3 Open the battery compartment. Insert the supplied AAA battery with correct polarity (+/-) as indicated. »» The unit switches to the last selected source. Switch to standby mode Press again to switch the unit to standby mode. »» The display panel is dimmed. Note •• The unit switches to Eco Power Standby mode after 15 minutes in standby mode. Set clock 1 In standby mode, press and hold CLOCK on the remote control for more than two seconds. Repeat step 3to set minute. Note •• If no button is pressed in 90 seconds, the system exits clock setting mode automatically. 2 3 4 Switch between standby mode and ECO standby mode: Press and hold for more than two seconds. Tip •• You can view clock information in power on mode by pressing CLOCK. 8 EN 4 Play CD AUDIO IN FM PRESET/ALBUM USB SOURCE VOLUME REPEAT VOL SHUFFLE Play from disc 1 2 3 4 Press CD repeatedly to select CD source. If not, press . MUTE DISPLAY PROG TIMER AUDIO IN SOUND CLOCK SLEEP Control play / / Select a folder. Enrich sound effect with DSC: balanced, clear, powerful, warm, and bright. Adjust display brightness. CD CD AUDIO IN FM PRESET/ALBUM SOURCE VOLUME REPEAT VOL SHUFFLE AUDIO IN MUTE DISPLAY PROG TIMER SOUND CLOCK SLEEP REPEAT (repeat) SHUFFLE (shuffle) VOL +/MUTE (mute) SOUND (sound) DISPLAY (display) Play from USB Note •• Make sure that the USB device contains playable audio content. 1 2 Press USB repeatedly to select the USB source. If not, press . Skip to a track For CD: Press / to select another track. For MP3 disc and USB: 1 2 Press Press / / to select an album or a folder. to select a track or a file. EN 9 Program tracks You can program a maximum of 20 tracks. 1 2 Press PROG to activate the program mode. / to select an 3 4 5 Press / to select a track, and then press PROG to confirm. [. . . ] Clock/timer setting erased •• Power has been interrupted or the power cord has been disconnected. •• Reset the clock/timer. EN 15 9 Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. because correct disposal helps to prevent negative consequences for the environmental and human health. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet. ) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. [. . . ]